If you like BoxMatrix then please contribute Supportdata, Supportdata2, Firmware and/or Hardware (get in touch).
My metamonk@yahoo.com is not reachable by me since september. Please use hippie2000@webnmail.de instead.

WLAN-Antenna-Obscurities 7590 AX

From BoxMatrix
(Redirected from Antenna-Obscurities 7590 AX)

BoxMatrix >> Accessories >> WLAN-Antenna-Obscurities 7590 AX @ BoxMatrix   -   IRC-Chat   -   Translate: de es fr it nl pl
News Selectors Models Accessories Components Environment Config Commands System Webif Software Develop Lexicon Community Project Gallery

WLAN Powerline DECT ISDN-DSL Bluetooth PBX-Systems Modems Cables-Adapters Power-Supply Casings Antennas Misc HW-Modding Research

FRITZ!Box 7590 AX-Image240.jpg
5th WLAN antenna 7590ax v1
FRITZ!Box 7590 AX v2-Image1.jpg
5th WLAN antenna 7590ax v2

WLAN-Antenna-Obscurities 7590 AX[edit]

Obscurities found in the FRITZ!Box 7590 AX [v1] and FRITZ!Box 7590 AX v2 WLAN antenna layouts.

Both models support simultaneous dual band 4x4 WLAN. The 2 bands are mixed to 4 dual band antennas:

But there's an obscure 5th antenna:

Facts[edit]

Facts about the 5th WLAN antenna:

  • It is a 15mm wire monopole which is a quarter wave 5GHz antenna
  • It is connected to the 2.4GHz (!?!) WLAN SoC, so it may also be a 15.5mm 1/8 wave 2.4GHz antenna
  • So far AVM never used 1/8 wave antennas, they would use a L-form folded quarter wave if space is an issue
  • It is NOT driven by a WLAN frontend like all other antennas, so the transmit power is likely low
  • In the FRITZ!Box 7590 AX v2 it is connected through a Murata test socket
  • Murata sockets are used for in-factory calibration of transmit power

Guesses[edit]

My first guess was it could be a sensor antenna for 5GHz Radar-Scan without disconnecting clients, but then the Murata socket would not be required, which only makes sense to calibrate transmit power.

A second thought was it may be 5 RX and 4 TX streams in 5GHz band, but then it's connected to the wrong SoC and MIMO usually can not work across multiple SoCs.

Maybe it is connected to the 5GHz SoC in an inner PCB layer, unlikely, since this would be unusual for AVM. They would typically use an IPEX-Cable to pass RF on a PCB across longer distances.

Another guess was it may be for short distance IoT usage, but there is no point in limiting the distance by not using a WLAN frontend and there's no 5GHz Smarthome stuff.

And finally - maybe the most propable guess - it may be a security check - a way to establish or detect a short distance WLAN connection for Mesh-marriage and 2FA,

If you have further ideas please get in touch!

Gallery[edit]

Sample images of the 5th WLAN antenna:
If you want to extend the gallery with own work then please get in touch. See also the Photography-Inspiration article.

See also[edit]

Credits[edit]

Fact-Box